Modding a Wii Hori stick with Sanwa Parts for Xbox 360: Part 3

New video series going over how to mod a Wii Hori fighting stick to use Sanwa parts(JLF and snap in buttons). I also wire it up to a 360 pad(you can wire it back up to the Wii if you want).

For PCB diagrams and a ton of other info check out
http://slagcoin.com/joystick.html

Category:

People & Blogs

Tags:

• Sanwa
• Arcade
• Stick
• Wii
• Hori
• Street
• Fighter
• Xbox
• 360
• Mod

[enzovoordt]

the screw you use to hold onto the stick (the screws that hold onto the stick itself/body) through the microswitches?

where do they hold onto?

at 3:44 its mounted but I wonder how because the topplate of the hori stick is thin where does cause your tut doesnt show how to mount it :P im confused

[CoverlessTech]

They screw into the threads that where already there. I unscrewed them earlier and just put them back in here.

[MrCheezybread]

Can i do the same thing with the Hori EX2 fight stick

[danteMdie]

Man, respect for the mod!

But seriously, you could get a TE with some extra 50 bucks :p That would save a lot of work xD

[sergiocl91]

Nachos!!!

[jlenoconel]

This was a pain to mod. Is the Madcatz a lot easier to mod than this?

[jonnitti1]

yo i got a jlf for my fs3.  the thing is the shaft is too tall for the thing to close. i looked up how to shorten the height and it said that i need to use a shorter shaft. can you show me how to replace the shaft?

[focushin]

which other video

[A1yola06]

yes

[JsBlaze5]

how much did all the parts cost cuz my stick just stop working and i might have to rebuild my stick i think my buttons are good but something not right