HK450 3D flight and crash (tail part come loose)

just trying to do 3D :) The bottom gear of the tail part comes loose and spins on the shaft,resulting in no power to the tail rotors and consequently, no control over the Heli.Solution is:::remove black housing plastic,you only have to pull them apart,drill a small hole right through the gear and the shaft, and then pass some fuse wire a couple of times through the hole,wind the rest of the fuse wire round the bottom part of the gear and metal shaft ,secure with epoxy.

see the problem part:
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=8543&P...

Category:

Entertainment

Tags:

• rc maroc
• The
• bottom
• gear
• of
• the
• tail
• part
• comes
• loose
• and
• spins
• on
• shaft
• rc
• helico
• hk450

[donakaal]

Even simpler solution...Alright this is what I did, get some 5 min epoxy, put it where the slippage happens on the shaft, let it dry a little longer than 5 minutes, tug on the bearing to see if you feel any slippage, and if not, let it dry another hour, it's gonna be ROCK HARD and I have had over hundred flights on my hk-450 bare bone kit ($20) and no slippage yet, recently checked again and still rock hard. Just make sure the e-poxy don't go on the bearing, just on the shaft and inner bearing

[rosiris3]

@donakaal very nice solution too, hope that can help somebody have the same probleme

[Faucon101]

c'etait pas notre jour etk!

[rosiris3]

je l'ai reparé mnt est prete pour un autre crash :)

[gerasismatas]

OHGASECÉ !

[TheTheRISKtaker]

what was with thos weried noises there so load my volume is full blast and right then AHHHHH