Electricity Amplification by Neo Magnet Test 2

Update February 17th 2008

This topic is located at the Overunity Forum: http://www.overunity.com/index.php?topic=4124.0;topicseen

Test 2: is the same circuit below but with no nickle surface, just 2 pcs. of 1/4" cylinder neo magnets with wires flattened and sandwich between them and holding by magnetic attraction. However in this arrangements I am now capable to pulse both poles of the magnets, north & south back and forth. Now voltage raises faster and higher (over 200 volts). CAUTION THIS KIND OF VOLTAGE CAN KILL.

Please note a verbal error in video: I say 7.7 volts when it is 17.7 volts

Category:

Science & Technology

Tags:

• Back
• emf

[prototype9000]

allways end up turning wires red and turning the magnet black doing that mabe theres something im missing

[gotoluc]

Hi prototype9000,

I also get the same thing if I try to pass too much current or if I'm on the wrong side of the magnet.

This method will not give you extra energy! if that is what you are looking for. I only shared it because it's an interesting effect. I does the same thing as a pulse circuit without electronics.

Luc

[prototype9000]

i was just trying to pulse it i guess 3 amps is to much

[gotoluc]

You should start with something smaller just to see the effect of the wire self vibrating on the side of the magnet. If the wire stick, turn the magnet 180 degrees. Do not use the ends of the magnet either. The fine single strand of copper wire should be between the North and South of the Neo magnet (center of magnet) This gives the best results.

Luc

[ken25taylor]

great video. Have you tried pulsing both at the same time? I want to make a spark gap and pump an 8hz db frequency and see if surrounding coils will get entrained. thanks

[onthecuttingedge2005]

always do your presentation on watts in and watts out, forget voltage and or amps. whether OU or not.

[fdoca]

Luc: Great video...now you got the high V, how can i charge battery bank use this V?? thanks

[PhotonDrive]

Luc: You can see from my "Mag Amp Gen" vids that I am flipping poles rapidly with the 3-phase cylider stack to get high AC-output? However, a guy named "KT services corp", ran a 3-phase with a Bedini cylinder last year (& then dropped it). Those into the "Overunity" angle may find my set-ups can be rotated fast by Bedini - THAT CHARGES BATTERIES at the SAME TIME!?! I think several are working on this right now, & for pure Fuel-Less Transport, it may be the BIG ENERGY REVOLUTION "TOUCHSTONE"!?!

[megavox]

I also tried trying to light small 15w light bulbs with the spike, no luck.

I also put a 86 ohm resistor in series and still got those readings. I also noticed puting the wiring and or steel around the transformer / magnet seemed to have increased the reading /rf burst. I can hear a louder rf "pop" in my computer speakers.

Caps seem to charge higher/faster. Led's work. Tesla used spark gaps right next to magnets in some patents. Maybe a red switch pulsed by a bedini motor into a super cap?