Nissan Quest front engine mount replacement how to
Uploader Comments (FriscoJarretts)
All Comments (30)
-
Hi my name is juan I got the same mini van ad ur wife. Few days ago my transmission stop working . I was wondering if you have a video showing how to remove a transmission for a 2001 Nissan quest Mimi van please email me to juan.linares71@yahoo.com
-
good job the way. idk if I should buya car that has this problem.owner probably runs with it like this with a heavy foot.
-
Can somebody show me how to replace the motor mount on the rear left side of
a 1998 NISSAN Quest?
-
I bought a 2000 Nissan Quest 1 1/2 months ago that is really in great condition, however yesterday the timing belt broke on me. It is now having the belt, water pump and tensioner replaced . While at it we looked at the front motor mount as I had been feeling a small lifting on the engine and yes it also needed to be replaced. Doing that also!
-
thanks,, very helpful video ,now i think am ready to tackle mines,i got front and back to replace,hope everything comes out sweet lol
-
You know...today I took off the old mount
but I can't install the new one
in your video I learned how to put the new one by pushing up the engine
thaaaaaaaaanx alot
respect from Saudi Arabia
How dies the broken engine mount cause oil leaks? I'm looking at a car that needs a new engine mount and has an oil leak so I'm guessing they are related. where does the oil leak from and is it hard to fix?
almostswedish 1 month ago
@almostswedish
It causes the engine to bang around in the bay and twist.
FriscoJarretts 1 month ago
I saw your video its good u take time to show others.my mother has same quest and i have the complete schematic master service manual ,the one that certified auto service mechanics use at the nissan dealer ship use.well reason why your mounts are going bad quick is cuz your supossed to tourque them at 58 to 65 foots of lb after u remove the support jack off it and and lowered the vehichle off jack stands.thens is when u finalize the ft lbs of tourque on the engine mount through bolt .
sikwitit765 1 year ago
@sikwitit765
That was done. I am not sure how that would make a difference. The mount tears its rubber, and is not the bolt.
FriscoJarretts 1 year ago
Yes you could do this on raps for sure. I just cannot get the ramps under the car. You will know when you are up high enough when the blots slide out easily. If you go up too high you will not be able to pull them out.
FriscoJarretts 1 year ago
I had a little piece of hard rubber that worked. A piece of wood will work too, just to not use the bare jack.
FriscoJarretts 1 year ago 2