racing mower build

Racing Lawn Mower Build
Class: Super Stock
Rules Built For: ARMA
Engine Specs: 13hp briggs and stratton
Chassis Specs: Custom front axle lowered the front 4" channeled the rear transmission in the chassis to lower the rear 4 1/2 ", 4" spindels with brackets, New ball joints.
Tires: Rear are 16x7.50-8 tires and the fronts gone from 15" to wider 13x6.50-6 for more traction.
Drive Line: 6" on the front 4" on the bottom of the jack shaft 6 1/2 on top of jack shaft and a Adjustable 4 1/2" on the transmission.

People to thank: Grasscar, Hoods Machine Shop, Outdoor Distributors, E.C. Distributing, Tires Plus, Ams Oil, Dunlop Belts, Mc MasterCarr.

Category:

Autos & Vehicles

Tags:

• racing
• lawn
• mower
• build
• american
• association
• fast
• loud
• briggs
• and
• stratton
• super
• stock
• lowerd
• start
• race
• exhaust
• gas
• custom
• new
• pulley
• swap
• to
• ratio
• engine
• burnout
• extreme driving
• motor sports

[musician1232]

what the speed of this with the pulleys u got

[V8Mike93]

@musician1232 24-25mph with 16" rear tires @ 3650 rpms

[musician1232]

@V8Mike93 ok thanks but i was goin to use your pulley sizes on mine but what pulley should i change to get a little more speed out of it

[V8Mike93]

@musician1232 6 on motor 4 1/2 on tranny. The front one.

[wastelandprovince]

where do you get your internal engine stuff at?

[V8Mike93]

@wastelandprovince Arc Racing

[V8Mike93]

@TheMowerdude Technically it IS some of the fastest mowers in the WORLD use Transaxles and i have another mower that is chain drive it makes NO difference but it is a Racing Mower Has Thether Custom Clutch Locked Differential with Ratio swapped Gears and where is your mower??? that you Race Regularly at National Events HUMMM??!!!!!

[V8Mike93]

@bytmeh thank you for your comment the wheels shown in the beginning are what came with the mower i CHANGED THEM TO 13X650-6 FRONT TURF SAVERS WHICH ARE THE SAME SO I DO NOT KNOW WHAT YOUR PROBLEM IS. Have a nice day.

[MowerStompin]

@MrDtpdtp You channel it out. So say cut a 4" square out of the frame where the transaxle goes, then make your brackets and your good to go. Go check is chassis video, the latest one. It will explain it if you haven't seen it. He did it for you :D

[MrDtpdtp]

how did u lower the back?

[V8Mike93]

@ismokewead420 $if i remember correctly $129 plus shipping got it from Surplus center.

[ismokewead420]

vari drive BLOWS! what did you pay for that peerless?