EFIE 1 02 Sensor Voltage Adder Device

www.neutronfluxlabs.com
This is a EFIE Device for modifying a Single Oxygen Sensors Output. This unit takes up less space than a pack of cigarettes. No giant project boxes like competitors. this unit's output alone will often be enough to lean out your ECU's Fuel trim to atleast -20% without further sensor modification.This unit has built in indicator lights and overvoltage prevention meaning it will stop pulsing positive voltage when you try to dial in a adder voltage above 1.50 volts. This until will pulse your "dialed in" voltage in 3 second intervals closely mimicking the standard action of an oxygen sensor and thereby on average adding voltage to the signal at the same time as the exhaust 02 sensor does. Made with High End electronics on a Printed circuit board. some competitors may state they have a printed ciruit board but they simply draw the traces on their boards with sharpies and resist pens and then etch. here at NeutronFluxLabs we have a proprietary PCB manufacturing method. 4 feet of solid core wire is included to get you started wiring this device to your vehicle and will often be the only length of wire required.Solid Core wire has its advantages as once installed this is a permanent installation and can be bent around automotive engine compartments and keep its bent shape. 30 day defect free warranty.

Category:

Science & Technology

Tags:

• HHO
• HYDROXY
• EFIE
• ELECTRONICS
• RESEARCH
• HYBRID

[jocell202]

watch my save money on fuel with one wire vid.

[pascalhumphrey]

are you selling this

[tdp1957]

My 89 chevy s10 needs to see a change in voltage which would act like an ac pulse but goes from 1 volt dc to 100 mv. would this help?