Vacuum Engine with Internal Valve Side View in Slowmotion
Loading...
Loading...
4,448
Loading...
1:22
Moteur Vacuum - Flammenfresser - Vacuum engineby Armapax5,793 views- 0:10
Vacuum Engine with Internal Valve in Slowmotionby JeroenJonkman2,134 views
- 4:18
Vacuum Engine Explainedby josephdupont1,700 views
- 0:06
linkage system animationby mozart67838,063 views
- 2:27
Vacuum engine (internal valve) Avaleur de flame, Flammenfresser, Flame lickerby Jepis3144,926 views
- 0:30
Flame eater Kurfuerst / Electoral Vacuum Engineby bengsmo3,402 views
- 2:05
Flame-Licker cooling - refroidissement moteur Vacuumby Armapax58,261 views
- 1:03
Flame-Licker Engine Model Automobileby RamonaSteam84,537 views
- 0:42
Stirling Engine- Flame Lickerby PullTab1,670,230 views
- 1:20
Flame licker,Avaleur de flamme,Fammenfresser,Vacuumby mavap6910,346 views
- 2:12
Flame eater Marc.wmvby HEETGAS5,117 views
- 1:00
Lamina Flow Stirling Engineby PalmRunner651,397 views
- 0:25
turbo vacuum motor.wmvby fritzarken746,370 views
- 2:25
water cooled vacuum engineby HTTTCenergetix3,853 views
- 1:11
Avaleur de flamme - Flammenfreser - Vacuum engine - Bengs "Nick"by Armapax5,296 views
- 3:33
new Stirling hot air engine from Maidstone Engineeringby maxitrak180,244 views
- 1:00
Unusual Flame Licker Engineby Cletrac11,938 views
- 0:22
Mini Moteur Avaleur de flamme, Vacuum engine, Flammenfresserby Armapax8,900 views
- 1:49
Thermo Acoustic Engineby JeroenJonkman5,757 views
- 0:18
Gakken flame licker car running.by duncandumpertruck8,420 views
I've just found this brilliant video! I see your piston actually protrudes slightly past the left hand edge of the port. Mine doesn't quite get there so the port doesn't fully open. Do you think this could stop it running? It still opens enough to draw in the flame, I'm at a loss with this engine! The only thing I can think is that my piston and valve aren't a good enough fit but they seem ok when testing. Many thanks, Nick
NickG24 2 years ago
I've just found this video and can see that your piston pushes the valve further open than mine. Your piston actually goes slightly past the left edge of the port where as mine doesn't quite reach it - that was a slight mistake on my part, do you think that could be stopping it running? The port still opens enough to draw the gas in! Many thanks.
Nick
NickG24 2 years ago