Tournament edition Madcatz PS3 fight stick dual mod tutorial step #2

Tournament edition Madcatz PS3 fight stick tutorial step 2: Fitting the controller into the case and soldering the wire onto the button's signal and ground.

Various songs by Ratatat , they are an awesome band, go check them out!

Category:

Gaming

Tags:

• Ps3
• Tournament
• edition
• Madcatz
• fight
• stick
• 4716
• dual
• mod
• mr
• bdotdot
• street
• fighter
• tutorial

[dkiss777]

hi mrbdotdot what did u use to paint the sides - and is it scratch resistance

[Mrbdotdot]

@dkiss777

Hey Dkiss777, the spray paint that I used is called duplicolor that you can find at NAPA, or any automobile store. It is very scratch resistant and even to this day I've seen no buffs on either of my fight sticks. It's pretty awesome :)

[Eternldragon1]

How did it end up?

[Mrbdotdot]

Good! I wired/soldered the buttons wrong though so the PS3 is wired correctly but the inputs for the xbox are a little off :( works great otherwise!

[OverKiiiillll]

so what was the end result after soldering everything(llike did you solder all the signals and only one ground or what) a picture of the end result (finished PCB after soldering) would help ALOT also. i plan on dual modding mt own TE stick by myself.

[cellomaster]

god that was pissing me off watching you try to get the case on at the start

[rdo6]

I'm looking for that small Home/Return/Turbo pcb where can I buy??

[davegong]

@lukeweizer If you're TE stick PCB is broken I'm pretty sure you can grab an SE stick, gut it and use that board. I'm almost certain they are the same board. But I could be wrong check SRK for confirmation.

[lukeweizer]

My fightstick is broken and I apparently need to get a new PCB board. Are they easy to replace? Does it involve soldering or anything or do I just pop out the old one and snap in the new one?