magnet wheel v-gate replica (Frl.)
Uploader Comments (ardan37)
All Comments (69)
-
@lukusr And could you do that at sever places around the v-gate. The single selenoid pusher would push all the individual jump magnets at the correct point
-
use enough bar magnets spread around the outside to get enough thrust to push past the gate
-
doesn't it take more energy to adjust the magnet in your hand then the wheel produces?
-
v shaped magnet in middle of rows will work too with a little magnet configuring
-
ground interupt on the magnet, triggered off the wheel rotation
-
@ardan37 just put a cam over the wheels to lift the magnet...hope it works
-
couldn't you simply make a pulley system that creats a 2 way piston synchronizing the free magnet? or the energy the spinning produces is smaller than the energy needed to move the free magnet? (probably it is, and that's the reason why these motors just don't work... but anyway...)
-
FRACASO TOTAL!!!
get yourself a solenoid to push/pull that magnet at the correct point in the cycle, and you got a motor. more effecient than electromagnet cuz it only needs a short burst of juice vs a continuous applied voltage. great setup you have now. rotor and stator are both permanent magnet powered and you only provide the curcuit reset energy.
lukusr 2 years ago
thanx, a lot of responce... this is great !
i'm a busy person another wheel whit only permanent magnets and only 2 lower that can wear out is coming up,
thats what we all want.
if you want real free energy you have to build (try) it yourself.
thanx...Ard.
:)
ardan37 2 years ago