62,543
Uploader Comments (DIOSpeedDemon)
see all
All Comments (43)
-
Will you do a close up on the MXU 50?
-
can anyone tell me if there is a video on how to remove the body plastics from a scooter for better access to the carburetor and enqine? thanks, james.
-
@MultiBrac it will be the carb just clean it
-
Hey
- I have a problem whit my scooter, the carb is exactly like that one. The problem is, it drives normally whit a gentle twist on the throttle, but when I floor it, it dies and if I let go off the throttle, it runs normal again, can you say me what the problem is, please :)
-
i would just buy a new carb?
-
was that a gunter 14 or 12 mm carb?
Loading...
get a ultrasonic jewlery cleaner and leave the jetts in that for a while.
TheOnlyMXRider 7 hours ago
@TheOnlyMXRider FUCK !!! THAT IS A DAMN GOOD IDEA!! SEE, I LEARN SOMETHING NEW EVERY DAY, BRILLIANT. THANKS rh dsd
DIOSpeedDemon 4 hours ago
are the carbs of a honda dio and honda tact the same? coz i got a tact here at home but it's about a year since i last used it. it fires up but dies on me in about a minute or so. you think it's just the main jet?
hajileh 11 months ago
@hajileh Sounds like the main jet clogged with old dried gas. Buy some starter fluid and and squirt a little into the carb and fire it up, if it runs for a second and stops, the main jet is clogged, get a needle and punch thru the obstruction on the jet and it should work fine. This is the most common carb problem in the universe.
DIOSpeedDemon 11 months ago
i dont know why my scooter wont start...it cranking but just wouldn't catch...i don't know is the spark pug is corroded...its hard to access...
dsrevo79 1 year ago
@dsrevo79 Try a little starting fluid in the end of the carb and see if it fires up. If it fires for like 3 seconds and quits, the main jet is clogged and needs to be removed and cleaned. RH DSD
DIOSpeedDemon 1 year ago