Complete Glock: Magazine Disassembly/Reassembly Excerpt
Top Comments
All Comments (38)
-
Muscle it off???? This is the same guy who in a commercial video stated that when you removed the trigger pin, it was the only part where you had to use a hammer and punch while disassembling a Glock. Using a hammer and punch to remove the trigger pin will damage the Slide stop lever. My personal opinion... this guy never took a Glock Armorer course and spits out a lot of bad advice.
-
Thank you so much been trying to clean my mags for a while and couldn't take it apart. I was scared I was gonna break my mag. But now I know how to take it apart tks for this detailed vid.
-
I wonder if this guy was ever in the U.S. Army which I believe created the non-existent word "orientate". It's painful to hear.
-
good job !
-
That's not even a punch he is using, it's a finishing-nail setter.
-
Nice, but you missed the most important part! You need to depress the floor plate about a centimetre into the mag, THEN SQUEEZE THE SIDES NEAR THE CLIPS, then move the baseplate with a lot less force. I have stripped many types of mag. Most baseplates are held in place by the nipple on the bottom. Glock have added side catches and I am amazed how many people do not know how to strip these things properly. Remember excessive force probably means you are doing it wrong.
-
nice video
Great video but black gun with black shirt makes it hard to see the detail. Needs more contrast.
Bearaway 2 years ago 6
STOP!!! do not muscle anything off: watch my vid at Figure Eleven above
FigureEleven 1 year ago 5