This video provides you with the correct advice for applying our non slip tape safety grip onto an internal or non-porous surface; it is a very simple procedure. We recommend the surface is above 10ºC and is not wet. For applying to a porous surface such as wood, concrete or stone we recommend our H3506 primer, for further information please watch our alternate video which demonstrates the use of H3506.
To clean the surface prior to application and remove all grease and contaminants we recommend soaking a clean, dry cloth or rag with H3508 hen in single sweeps clean the surface where the safety-grip will be applied. This should dry within a few minutes.
Holding the non slip tape safety-grip remove the backing liner, press down onto the surface. Once applied we recommend firm even pressure; this can be done by hand or with the use of a seam roller which Heskins can supply at a low cost. For high traffic areas or if it is to experience a lot of edge scuffing we recommend the use of our H3502 edge fix, this material is a compound that helps to prevent edge failure. The tube is similar to a tooth paste dispenser. Simply apply a very small amount down the edge of the safety grip, it should touch both the non slip tape safety-grip and the surface, only a very small amount is required! Once applied it sets within a short period of time leaving behind an almost invisible edge protection. The material can be walked on instantly after installation and will provide you with a very durable and effective anti slip surface. For more information on any of the products Heskins manufactures please visit http://www.heskins.com
Thank you for the comment!
Best regards,
Larry
HeskinsAntiSlip 2 years ago
seems like a good product
metamick 2 years ago
It is! The whole World should be buying it!
HeskinsAntiSlip 2 years ago
Great video guys. Well Done.
paintshopDOTie 2 years ago
Thanks for that, we did put a lot of thought and effort into them.
HeskinsAntiSlip 2 years ago
Glad you like it!
HeskinsAntiSlip 2 years ago