Video 1

New 1 clyender engine on water.

Category:

Science & Technology

Tags:

• Waterfuel1978

[delorjoy]

Del Here

I still can,t tell where the other wire on the

spark plug goes would be good to know

thanks

del

[s1r9a9m9]

The wiring on the videos was a dead mans way to do it. The wires sould be wired up like this. Ground from batt to plug base, Hot to coil then to a light to keep power pulled through it, Plug wire from motor to coil then to the top of the plug. Watch video three and see the diagram on it there. The inverter is not needed.

[hydrocarz]

you said pick it apart! so i hollar moonshine!!! prove that your using water and not moonshine and i'll be a happy guy.. oh, and thanks if your for real, scarecrow just checking things out.

[s1r9a9m9]

Did you notice the water dripping over the place where all the sparks were flying around. Yes the jumper cables did get hot and steamed when the water got on them. watch close and you will see this.

[slider1860]

I guess that if he drank it that "still" (no pun intended) would not prove anything.

[s1r9a9m9]

Would you make all those sparks around that kind of stuff. it would burn but you couldn't see it until the plastic started to melt.

Yes its water in the bottle. watch video 2 .

[SmartScarecrow]

all right, here's what I see wrong.

1) the lead to the inverter mentioned by seriescell

2) the one handed connection of the hose off camera to the fuel filter took a lot of talent

3) the tin can containing the relays, diodes and other required electronics sounds hollow and has no heft to it

these are the issues that lead me to believe this is a hoax. much as I want it to be real, I got to call you out. please prove it to me. I want to believe.

[finefilth]

very old technology kept away from humanity by the usual suspects

[aaaflooddrying]

@aaaflooddrying Thank You, Clay



[aaaflooddrying]

@s1r9a9m9 After the hot goes to a light where does it go after that? Does it go too top of plug?

What affects do you gain by adding and deleting windings to all coils? The copper, the red, the black? I am not that good with electronics, so the more basic and detailed the answer the better or it will go over my head.

I also noticed in video 1 that the big copper wire seemed to still have the insulation on it, does that have any affects on how it works.

[SergeHumphrey]

What was the exact wiring used in this video?

[fafadi13]

I am very happy to see that his walk me so I will work on type of system, I advise you had given it does not use Faus water directly, false inject water directly into the cylinder under a small water vapor, you Vairé his works much better.

[brianempson]

You dont know how correct you are. The timing needs to be retarded past tdc, but the engine should work somewhat in it's stock timing too.

[steblizz]

a good way to make plasma ;-)

[fredrik999z]

Ok, so what you see here is an engine running on water. But it is not running on water alone. The inverter is attached to the plug and battery is attached to a charger. Look at the wirings and you will understand.