Simple gas feed system to GEET bubbler

Simple gas feed system to GEET bubbler.
Kind of a vacuum sytem.

Category:

Autos & Vehicles

Tags:

• GEET
• Plasma
• Reactor

[2550osiosterdalen]

There is plenty of room under the hood in a VW TDI, so I though of mounting the microwave beside the battery ;)

So you actually get more of mileage with adding a small amount of gas vapour?

I think I have a sweet spot with my humidifier around 20% water to 100% diesel. I will drive about 100km with this adjustment and then try the same setting with microvawe-boiled water.

[2550osiosterdalen]

What are your thoughts behing having both water and gas in the vaporizer?

I have found the limit with my vaporizer now, I have felt loosing power with adjusting too much water. So I might be able to find a sweet spot soon. I will then try with microwaved water too.

[GTIBully]

I'm using a simple bubbler with gas and water in it. I have it fed to the intake and it works great. My car went from 44mpg to 46mpg highway with it. Vacuum is from intake just before throttle body. Working on a better one.

[2550osiosterdalen]

So you haven't shut off the ordinary gas feed to the carb then? You are feeding the engine with extra gas and water vapour? Have you tried with only watervapour?

I am testing out a humidifier-system in my intaketube, between the MAF and the turbo. It is a sock..! inside the tube with the toe cut off to not limit the airflow too much.

I have a small tube just above the sock, dripping water on it just inside the tube. I have a needlevalve to control the amount of water to the system.

[2550osiosterdalen]

I have an increase with that too, but not as much, yet, as the HHO Steamer Cell. But I am beginning at a low dripping rate and moving up. Fill up by fill up.

[onecraftydude]

I am using a float valve and seat from a small engine carb. I just made a bracket for the float so it shuts the valve when the level is reached in the bubbler.

[2550osiosterdalen]

Thats smart :)

[GTIBully]

The gas will not mix with the water and will stay on top of the water. I've been running the vaporizer for a few days on about a half cup of gas. The water level has stayed the same.

Where will you be mounting the microwave:)

[GTIBully]

I wanted to try hooking up a Eureka Hot Shot steam cleaner to the intake but haven't tried it. It shoots a fine pressurized stream of steam. Hope someone tries it and reports about it. Keep up the work you're doing!

[GTIBully]

Everything on the car is still stock, mechanical fuel injection,..except for an EFIE controller i built to ad voltage to the 02 sensor which i use with or without hho. Not using hho now but after my tests with vaporizer.