Completed the JK flip flop driver for HVDC HHO Gen

This is video shows how the JK flip flop circuit is wired and working to drive a toroidal transformer to produce High Voltage DC. The driver circuit only heats up a little bit and is able to run at 120 volts at 30 AMPS.

The transformer puts out about 170 volts AC without load and about 50 volts AC loaded. The power to the plates is limited by the amount of current I pull from my power supply.

I have PC power supply that will be modified for future work. And an air tight container and a measuring device is to come.

Category:

Education

Tags:

• HHO
• hydrogen
• electrolisis
• water
• fuel
• Science

[KX36]

nice scope... vintage :D I wonder if it has vacuum tubes in it...

[PeteDog444]

yup it sure does. It gets the job done.

[christaisstillhere]

were you able to produce a system capable of running a car on water or did you need to use a mix of gas and hydrogen? Will it produce enough gas to run a 5 hp motor on straght hydrogen?

Is this the same setup as "Bob Boyce's Pulsed Flectrolyser System"?

[PeteDog444]

NO too all.

[PeteDog444]

The Herz was variable but with in the audible range. I didn't use one set frequency. For the most part it was an in efficient water heater at best. I am now using technologies developed by Bob Boyce. I is a Tesla type systems. That is all I can say about that period.

[crackahcrackah]

are the secondaries wound first and then the primaries wound over the secondaries in this?

[PeteDog444]

no I wish they were but that is way more work than I'm willing to do.

[chasjokeatbp]

Mr. Daniel dingel hho generator is more efficient putting out 45percent efficiency. Verified by independent govt. agency. On one video you can see right away the production of hydrogen feeding to the combustion engine, driving a Honda car. Pls. Search dingel water car. Thnx...

[madamerotten]

Wow, a Tek 310! Not many of those still around!

[scum525]

can you explain how an  hho cel can act as a capacitor? stan meyer had a choke coil whatever that is. but i would like to get someone to put this concept in layman's terms

[Mastahscott]

man no offense but your using 8 amps off the power supply , ditch all that crap and hook the 8 amps straight to the plates , youll produce way way more . all that is a waste

[MichaelCouch]

You need to ditch the baking soda. It degrades into NaOH anyway eventually. But the carbon will coat your plates and keep the catalytic layer from forming through conditioning which optimizes your production and greatly improves the quality of the HHO or Hydroxy gas. See Patrick Kelly's Chapter 10 pdf.