@CHAPxKILLA if it is tuned, properly, then you need to tighten the slipper clutch, the tight it is more torque it will have. some people dont like wheelies so they have it looser.
@CHAPxKILLA you just need to tune it..Factory break in is rich on the high speed needle.. Lean it out a 1/4 turn at a time until performance doesn't get better then back off a 1/4 turn.. After that, it'll be hard to keep the front wheels on the ground
How do you do a wheelie on a rc truck? I just got a T-MAXX 3.3 and I broken in the engine. But when I accelerate and the front wheels don't lift. Any help?
havent seen such a perfect tune in a long time good job mate!!!!
orion2020 3 months ago
what percent fuel do you use in your tmaxx
123hobao 3 months ago
@happydays875 thats where your wrong some you don't have to put the bar on but some you do have to tune fine tune to get them to do this.
matthewmarrs123 4 months ago
@ACDC5540 you don't have to tune it you just put the wellie bar on and go
happydays875 8 months ago
Now that is a fine tuned machine.
SuperIrish222 8 months ago
oh hell yeah! that was awesome i gotta tune my tmaxx to do that!
ACDC5540 9 months ago
@CHAPxKILLA if it is tuned, properly, then you need to tighten the slipper clutch, the tight it is more torque it will have. some people dont like wheelies so they have it looser.
oldcyclist1 10 months ago
@CHAPxKILLA you just need to tune it..Factory break in is rich on the high speed needle.. Lean it out a 1/4 turn at a time until performance doesn't get better then back off a 1/4 turn.. After that, it'll be hard to keep the front wheels on the ground
smileztfs 11 months ago
How do you do a wheelie on a rc truck? I just got a T-MAXX 3.3 and I broken in the engine. But when I accelerate and the front wheels don't lift. Any help?
CHAPxKILLA 11 months ago