solid state BEDINI charging hilti dead batteries

running at 5 khz 14.86 volts / charging 12 NmH 3AH HILTI batteries
Tesla impuse tecnology by Bedini
that charges the batteries isn´t the BEMF because it is lower than EMF ! what charges the batteries is the spike (impulse ) !!!!!!
better than this only the Renaissance chargers....or bedini motors that have a better income because they use the magnetic field to run a rotor that can do work !!!!

Category:

Science & Technology

Tags:

• BEDINI
• SOLID
• STATE
• RENAISSANCE
• TESLA
• IMPULSE
• TECNOLOGY
• RADIANT
• ENERGY

[Machiuka]

In what period of time do you made the recharging?

[spdelgado1976]

more than 48 h because i used low input corrent

the important here is the time that the coil is turned on ! around 100 microsecond

remember that is the potential of the spike that is free ( between 300 to 600 volt ) ! this is the secret !

[spdelgado1976]

the generator of signals can generate varoius frequencies ( 1 hz ; 5hz ; 100 hz ; 1 khz ; 5khz ; 10khz .... ) , it´s is very stable because it is controled by a quartz cristal

see my another videos were i show the frequency in the coil using my multimeter that can measure frequencies ....

[marthale7]

I am curious as to how they do under load. Thanks for sharing!

[spdelgado1976]

they work very well after the first charge !!!

they were dead and now they come to life i will make a video but of corse it doesn´t prove nothing because people cold say they were never dead !!!!!

my conclusion is that i have a good timing with 5khz pulse and i can tell you when the voltage is less then 12 V ( in the battery ) with a load i have very power stored in the battery without doubts !!!!

[electrician725]

That is what I am doing, calculating the circuits required for ~100# of wire :D

LMK what U think Guru

Rob

[TheGuru2You]

Good Job! You are very close to limitless power.

A Hint: A bigger Coil with the same resistance will result in the same input power needed but the output power (back emf) gets way bigger!

[marthale7]

Congrates. I am curious how you set the 5khz on the input. ( if I understand the input board. )

You should check out the Joule thief circuit as well.