MOV00013. Bedini wheel BEMF through secondary with magnets . ON SOLAR !!!CAP AT MAX FROM SOLAR PNL

In this vid i collected the BEMF pulse and fed it into second coil primary. The power is sent through a bridge rectifier and used to light a 110v neon bulb. After collecting in a 2000v 0.92uF cap with a high voltage MOT diode connected to this cap positive .
The primary power coil is a single coil with a read switch laying on top of the coil windings creating a multiple vibrating frequency as the power passes through it . BEMF is collected at the power-in side of this coil and fed to the secondary bifilar coil for high voltage power collection. I have found with the use of repelling magnets attached to iron cores for fine tuning of the coils it is possible to adjust the bedini wheel to maximise speed to power ratio. My wheel is running on a small solar panel 18v 120mA .
The noise that sounds like a combustion engine is in fact the magnets loose inside the wheels as they were only held in position with bluetack.
With the use of a reed switch as opposed to a transistor ,multiple vibrations can be found and this energy can be returned to the system.
I have had this setup reading 18v in the cap and if not over unity , it is still very efficient . However it is not possible to run anything of any significance from the wheel/ shaft ! THE NEXT STEP WOULD BE A TESTATHIKA SETUP TO GENERATE HIGH VOLTAGE AND THEN STEP DOWN TO GAIN AMPERAGE !!! FROM THE SHAFT.

Category:

Science & Technology

Tags:

• DIY
• electronics
• bedini
• solar
• motor
• BEMF
• free
• energy
• frequency
• pulse
• power