NEX Multi-Cut

http://draster.com/
The Multi-Cut tool integrates three tools in one: A Split Polygon Tool (Cut), a Cut Faces Tool (Slice), and an Insert Edge Loop To The Multi-Cut tool integrates three tools in one: A Split Polygon Tool (Cut), a Cut Faces Tool (Slice), and an Insert Edge Loop Tool.

Cut:
Left-Click on any component to drop cut points, Right-Click to complete the cut. The Backspace key removes your last slice point.

Slice:
Left-Click in dead-space (outside the mesh boundary) to drop a slice point, Left-Click again to specify a slice plane, Right-Click to complete the slice. Alternatively, you can Left-Click drag to create quick slices. Finally, Middle-Click-Dragging will allow you to start your slice while your cursor is over the mesh. The Backspace key removes your last cut point.
Note: Only edges that are within the slice plane will be sliced. If backface culling is enabled, it will prevent slices from going through the other side of the mesh.

Insert Edge Loop:
Holding Ctrl and Left-Clicking will allow for quick cuts to span across the entire edge ring. Middle-Clicking while holding Ctrl will insert the edge-loop exactly in the middle of the edge ring path.

For all three tools, holding Shift will snap the cut points to percentage increments specified in the Multi-Cut contextual options.

Category:

Film & Animation

Tags:

• Maya
• 3d
• tutorial
• NEX
• dRaster
• Split
• Polygon
• Cut
• Slice
• Insert
• Edge
• Loop
• Modeling
• Naaice

[Kiyamlol]

thank you :)

[voidreamer]

hell yeah!

[LuciferIScute]

WOW ur great



[quesevayanaldemonioy]

great