How to set up an LDP skateboard - Part 3 - from pavedwave.org - long distance skateboarding

Take off the hangars to make tightening down the baseplates easier.

You will likely have to use some kind of shim or washers to make just about any non-Bennett bushing fit properly in a Bennett truck. The Bennett barrel has a very unique height. In this video I'm using an extra thick type of washer that was machined by Spencer Smith. You could use 2 or 3 thick washers to achieve the same, or even shave a thin slice from another bushing.

I tend to run a rear truck hangar that is slightly narrower than the front hangar, and sometimes the same width. I rarely run a wider rear truck.

More here
http://pavedwave.wordpress.com/help/

Category:

Sports

Tags:

• skate
• skateboarding
• skating
• LDP
• pavedwave
• gear
• setup
• long
• distance
• pumping
• pump