how to replace a motorcycle clutch
Uploader Comments (halosavage)
All Comments (33)
-
Thanks mate .... and after how much kms do u recommend to change the plates ? i finished 1200km and now gear shifting has become a bit jerky ... i think its time to change .... what do u think ?
-
@Gireesh092 That means your clutch cable is stretching, you need to keep it tightened up, just tight enough that the rear wheel should not spin faster with throttle pull. And you're burning your clutch easily.
-
Hey i have a question to ask .
I put my bike on centerstand ... start the engine .. holding the clutch i shift to 1st gear ( still on centerstand) and the rear wheel start to rotate ( even when the clutch is fully pulled) rotational speed increases if i pull the throttle .. is this normal ? Pls reply ...
-
Great vid man, well done. Cheers
-
Thanks for posting this. Please post more!
-
@halosavage it could if the clutch isnt fully ingaging it would cause the gears to slap and that also would explain the grinding noise when i take off.
my dirtbike makes a grinding noise when i take off and when i down shift it makes a slapping noise what do you think i need
NCcoinDigger 4 months ago
slapping noise like metal against metal? check your chain and sprockets for wear
halosavage 4 months ago
@halosavage brand new chain and sprockets i keep chain adjusted maybe my clutch cable could use some adjusting
NCcoinDigger 4 months ago
clutch cable should have anything to do with it... check your clutch? I'd have to hear it..
halosavage 4 months ago