08 Lancer - Tsudo N1 Fix

This is a possible fix for the Tsudo N1 exhaust hanging too low. It can also probably fix the rattling problem.

Category:

Autos & Vehicles

Tags:

• 2008
• 08
• mitsubishi
• lancer
• de
• es
• gts
• ra
• ralliart
• evo
• evolution
• project
• projectlancer
• projectlancer.net
• www.projectlancer.net
• houstonlancers
• houstonlancers.com
• www.houstonlancers.com
• Jason
• jmoreau10
• tsudo
• n1
• exhaust
• muffler
• hanging
• too
• low

[kbrun13]

hi J4SONM i asked u a few weeks ago and u gave me a link to buy the exhasut id liek to say thanx it sounds much better in real life mine sounds really deep and mine didnt have the hanging to low issue i found that if u use the right hangers it hangs find

[J4SONM]

That's awesome man, do you have a video?

[Shihtzu1968]

See if you can get shorter bushings, or bend the hangers to fit in the right holes. The holes you have them hooked into are for the play when your exhaust moves, using those will stress the bushings in the long run and they can fail. Also you can measure and bend the piece hanging out, instead of the clamp. Happy modding :)

[J4SONM]

Those are all good suggestions, thanks. I no longer have the Tsudo anymore though so I don't have to worry about the hangers.

[lowkeyneon]

mine use to rattle till i backed into a damn concrete pillar in Croatia while on vacation.... dont rattle no more though! LOL

[envalid]

thanks for the tips man

[wilchris2]

can i have the link of where i can buy it?

[anishsen]

Ryan, your exhaust rattles probably because it's hanging too high. I didn't install it the way it's shown on this video, therefore the gasket connection is not touching the axle. My rattled when I first installed it, but I readjusted it to hang lower which eliminated the rattle.

Remember, the stock exhaust is close to 50lbs so it hung lower. The Tsudo exhaust s around 25lbs so it doesn't hang low, creating a very little gap between the gasket connection and axle. Also look at the exhaust pipe

[anishsen]

I just installed my Tsudo in my 2010 Lancer last night, I recommend using the stock gasket to have a better seal. The gasket that came with the exhaust is a little bigger, which causes the exhaust to slide and move around.

[ryans998]

okay, so i commented on another video i installed mine last night today is the first day i drove it its rattles like a mofo asked about your bolts i have mine tightended to the point where my springs are compressed all togother  looking at this vid your springs are almost fully opened did i severley overtighten

[J4SONM]

They're called Rhino Ramps

I got them at AutoZone for like 40 bucks

[HeeVindinho]

ahh nice :) you made a video of it! Thank you so much, haha I have a stupid question though...

Where do you buy those black plastic bases..like the thing you use to back up the car and goes up so that the tail is higher for you to work under the car...haha I don't what they're called...haha where do you buy those and what are they called?:S