Mirror-like result after lapping my Q6600 G0
Uploader Comments (kim314)
All Comments (143)
-
I lapped my q6600 and heat sink, I saw what looked like a 2c drop in the temperature. Not sure if I did it right. If I can remember properly I gave up after 5 hours of not being able to make the surface perfectly flat, I was able to get the mirror finish though, well kinda. You could see the scratches but there was a good reflection going on.
-
Zo, hij ziet er behoorlijk opgeLAPt uit! XD
-
welke grit heb je gebruikt als laatste? is 1500 genoeg? of best nog hoger gaan? En ik heb ergens geleze daje druppels water moet gebruiken (om te slissen eig dan), klopt da?
-
ik moet dat niet doen ik hep en VAPOCILL pc bak mijn cpu is dan -12°c
-
A M A Z I N G !
-
its not mirror perfect~ you can see the whirls around the lights from the ceiling~ :D
-
i bet u just put the 50€ bill there to show off...
-
It's quieter than a fan basically and toy can take the heat ouside the case instead of blowing hot air around. The amount of cooling is still limited by the ambient temptrature around the radiator and it's no more effective than a large copper air cooler.
-
u can lap my stuff anytime! relly nice work !
-
only if your ambient temperature is 10C even with water cooling you can only get as cool as the air blowing through the radiator.
wow goed gelapt ftw =D is echt net een spiegel, maar dan in ut oranje :P
uut0 2 years ago
En hij leeft nog altijd he!! Al twee jaar!
kim314 2 years ago
vet, mijne was gestorve xP. heb je em al overclocked? en wat zijn je temps btw?
uut0 2 years ago
kijk eens bij mijn andere videos
daar staat een temp read out met ijs water op 4Ghz
Nu staat ie op 3,75Ghz en komt niet boven de 60 graden op full load
kim314 2 years ago