Bounty Hunter Energy Projects present Bedini circuit diagram
Uploader Comments (Elcanom)
All Comments (15)
-
nice job. Could you do the same for a solid state bedini setup. That is the one I've been stuggling with.
-
The negative on the primary battery go’s to the inner 20 gauge wire on the coil which also go’s to the emitter on the transistor and the inner 24 gauge wire from the coil go’s to the collator on the transistor then the neon bulb is connected to the emitter and collator is there any problems you see in this hookup? I noticed when I put a drill bit in the coil it shoots it out and my core is made of drill bits. what on earth is going on? And can the coil wire be directly connected to the emiter
-
The potentiometer is connected to a 24 gauge outside coil wire. My 1N4007 diode is connected to the positive on the secondary battery. Then the outside 20 gauge wire runs to negative on the secondary battery and on the positive on the primary battery.
-
Nice video! Hi I have been trying to get the bedini motor to work, but the wheel just comes to a stop. My setup is 1N4001 diode is connected on the emitter to the base on the transistor. Then the base is connected to a 470 resister. Then resister is connected to the potentiometer.
-
is there a sub for the transistor radio shack dont show one of that cross reference and yes which post on the variable resistor
-
great video, very helpful, Thank you
-
what sort of battery are you using and how many volts
Thank you so much
Elcanom 3 years ago