#001-HHO cell 2.3liters/min
Uploader Comments (autos432)
All Comments (16)
-
@nh3we completely inappropriate. there are kids on youtube, you know
-
you planning on replacing the electricity>
-
can i get a picture of your cell inside? plz
-
how much power do you need to put a dent in a piece of copper with a nail,not much i guess
can you kill a person with the same energy?
No?.....
yes,if you hit a bullit with it
that is what hho does to your fuel
why is this so hard to see?even with thermodynamics?
-
does this water car thing really work.....so if you had 10 of these hydregen generator' using 2 kilowatts of electrisity each 200 watts each....and bolt a few extra altanators to you car....to make you 2000 watts.....then burn it all........will this make the 50 kilowatts I need to drive....
-
so 11.3 volts times 18 amps = about 200 watts
....
-
Nice job man - keep up the vids!
-
Nice cell, but what would the HHO cell be used for? Just building for fun or are you going to apply it to something?
-
actually i believe the best production of gasses from the least amount of input is between is obtained when using 2 to 2.3 volts and there is a corresponding voltage to amp. ratio that creates this most effecient production with a .9% electrolyte solution. this is achieved by designing a cell based around the input voltage to be used.
-
Defiantly does. See my reply to LabRat, above.
what was the amperage draw ??? 40 amp? 50 ???
marienkiffe 3 years ago
Current in this clip is 11.3 volts @ 18 amps.
autos432 3 years ago
howw ! 2.3 lpm .can you show us you plates and the dimentions etc thanks
sergelacassetkd 3 years ago
The cell is 24 plates 2.5" x 5.0". Plate spacing is 0.060". I didn't record the concentration of Koh to distilled water, just added a little bit at at time until I got the amperage draw I wanted.
autos432 3 years ago