Cylinder Honing
Loading...
Link to this comment:
Uploader Comments (sixty9below)
Top Comments
-
1st off ur not suppose 2 use an air tool it runs at 2 high of an rpm 2nd mistake u want the little scratches ur puttin into it at a 45 degree angle witch i can clearly c ur not doing this is so that ur rings seat better
1 year ago 8
Video Responses
All Comments (14)
-
1200 rpm max is usually the recommended limit for a honing.
-
I have a 6 cylinder block if I use this process I am going to write now is it good :
first I am going to use that type of tool that this guy used than I am also going to go on a flex hone tool is this process the right way ???
-
Your dont push the honing tool deep enough. It must come out the bottom as well !!! Over shoot should be 1/3 of the stone on both ends.
-
can you please explain to me what this does? i have a cylinder that has shiny spots on it, would i hone it to get it fixed?
-
You're an idiot..
- 11:00Straight Razor Honing - Part 2: 1000 gritby ToxIkWaste64,978 views
- 1:24How to hone the Cylinderby RicksGarageprojects12,243 views
- 0:22Block Honingby carpartsmachine53,915 views
- 3:53Engine Rebuild 101 - Part 4 - Cylinder Honingby submarineboat12,276 views
- 3:33Bob Kramer: "Honing Your Knife" presented by Zw...by SurLaTableCorp16,834 views
- 2:591.4 Machine Tool Basics -- Lathe Controls -- SM...by SmithyCo74,323 views
- 2:52Rotax engine top end cleaningby videoclipits14,498 views
87 videos
- 0:41Honing an M3's Cylindersby breakbeatzboy22,996 views
- 9:56Grinding and honing a chisel freehandby gidonreid37,297 views
- 5:11cylinder honing classby loroleyrey61,812 views
- 2:05PS2VXL Hone - Winona Van Normanby WinonaVanNorman10,186 views
- 1:26Quickly and cheaply repair any worn engineby enginerestore253,278 views
- 2:11Hydraulic Cylinder Honingby honingcraft10,802 views
- 1:49Barber Honingby xmacd11,809 views
- 2:29CYLINDER DISTORTION AND DECK PLATE HONING ON CU...by pdm11225412,644 views
- 4:23Pro 1 Racing Heads: Diamond Honing a Plated Cyl...by ShortBlockCharlie9,397 views
- 2:16Motorcycle and ATV Cylinder Hone Instructions -...by RockyMountainATVMC74,890 views
- 3:07Kawasaki Cylinder Honingby fiatnutz60,335 views
- 0:16Crank Straighteningby carpartsmachine34,994 views
- 9:55Brush Research and the Flex-Hone® Toolby BrushResearch26,732 views
Are you tryin to bore it
maxpaul11 2 years ago 2
No, it was being honed so that new rings would seat correctly
sixty9below 2 years ago