AW55-51SN / RE5F22A Transmission Solenoid Repair and Valve Body Rebuild PART 1

SHIFT AND LINEAR SOLENOID CHECK AND REPAIR USING TRANSGO SHIFT KIT.

Category:

Autos & Vehicles

Tags:

• nissan
• valve
• rebuild
• valve body
• aw55
• aw55-50sn
• aw55-51sn
• re5f22a
• transmission
• repair
• houston
• flush
• aisin
• volvo
• equinox
• pontiac
• torrent
• vectra
• renault
• opel
• solenoid
• resistance
• ohms
• linear
• circuit

[hiramgutierrez]

Remove the cap using a bench grinder. need to remove the ridge as well.

[djlaiguana1]

Hi Buddy, I have a 93 ford Truck E-350 1 Ton Econoline - Van and something happened with the transmission (automatic), full fluid level its OK but when into 1 and 2 .... the truck runs good but for 3rd and 4th the RPMs go up and up (foot on gas accelerating), but the truck doesn't speed up .... i'm stuck on 1st and 2nd...

-Solenoid problem ?

-Should I reset by disconnecting battery ?

-No OD light flashes in dashboard.

-No ''CHECK ENGINE'' light.

Thanks for any help ...

[noerobbins24]

Your vid is popular on Tuvalu

[esovation]

update, found I had put the bracket that holds the three solenoids in backwards which repositioned the solenoids in the valve body. reinstalled VB and car drives perfectly.

[esovation]

Good video, thanks for posting, I just completed the VB rebuild (nissan quest RE5F22A), my orginal problem is corrected (slams 1-2, 2-1), now after reinstall getting what I think is the same complaint on pg. 4 of Transgo installation sheet. 2-3 cut loose, (also posts FC P0780 shift), I dont think i replaced or disturbed the 3rd band.....any sugestions?

[zimrang]

Hey how are you, could you give me some more advice and pointers?? My linears are ohming at 7-8ohms and the other solenoids at 15..........now, when you put the solenoids back on the valve body, are they supposed to be tight on there without being able to slightly rotate, or ithey supposed to move slightly, say quarter of an inch ?

[xzw6zc6]

Hi, Good video! How did you remove the cap (by cutting off..?). And the distance between cap and crimp will affect pintle travel. Pintle travel affects output pressure. So when you push the new cap in, the original canister height need to be maintained, right? Thanks!

[dianemarie909]

great video step by step good job

[hondasi101]

Great videos. I am having a hard time finding the repair kit for solenoids. Is there any way you could tell me were to get them. I dont work in a trans shop but do work in a repair shop. Thanks for your help.