Introduction To Pneumatic Props And Accessories
Loading...
Uploader Comments (mortarlover123)
All Comments (31)
-
Thanks! that was really useful!
I was wondering if there are ways to control the pressure of the pneumatics. I'm guessing I'd have to get a different valve, which isn't just an on or off valve?
-
@buddychristmasligh looks like it, usefull if you want to run 2 cylinders at the same time
-
DO U HAVE TO HAVE TO OUT PUTS
?
-
Very nice, good vid answered alot of questions
-
@mortarlover123 I actually have a video up of using one to controlling two small actuators with an Arduino. It was actually a design for school for a "camless" engine design. Still a work in progress but if you goto my videos and click the first one "Final Prototype Demonstration Model" you will get a little glimpse of it. If you have any programming skill at all you can program this board, very very easy. Also the circuit is really simple.
5:32
My First Pneumatic Halloween Bush Jumperby tomguy334,780 views- 6:38
Pneumatic System Animationby arcsanimation2,665 views
- 1:05
Controlling a solenoid with arduinoby jts3k13,460 views
- 0:14
Solenoid Valve Operationby pheldurin21,857 views
- 3:48
quim barreirosby anfalz25,017,606 views
- 0:27
Position Control for Pneumatic actuator using servo valvesby eohangeorge17,098 views
- 1:11
P&ID in under 2 minutesby CHEE47013,379 views
- 0:57
2009 Pneumatic Prop- Zombie Test 2by badunclemark6,047 views
- 10:06
Introduction to Pneumatic Control Systems: Clip 1 of 5by ictraining8,324 views
- 0:38
Controlling Pneumatic Solenoid Valve with Arduino using Transistorby wshelto61,868 views
- 7:53
Dial Controlled Electric Actuatorby inpositiontech14,629 views
- 2:28
One Shot Timing Circuitby mekanizmalar10,781 views
- 1:01
Pneumatic De-Skinned Halloween Propby easy96785,262 views
- 0:38
Getting Started with Pneumaticsby team22172,744 views
- 4:11
Pneumatic Cylinder.wmvby slausonm5,940 views
- 0:58
Servo pneumatic valve demoby THEMINDSHAFT18,087 views
- 2:45
FrightProps Quick Exhaust Valvesby FrightProps2,273 views
- 1:34
Pneumatic Aluminum Can Crusherby Kedge24105,016 views
- 1:23
2008 Pneumatic Prop- Tombstoneby badunclemark3,808 views
yes
mortarlover123 4 months ago
does it can be worked automatically with switches to open and close posion.
nalinmehta1983 6 months ago
@nalinmehta1983 if its wired up to a controller
mortarlover123 6 months ago
For a controller I would just use an Arduino Uno board and some transistors. Would cost like 30 bucks max.
wshelto6 10 months ago
@wshelto6 you should do a tutorial on programing , and building a setup with one, im so confused when it comes to circuit boards, same thing with prop one, but id like to have audio with my props too
mortarlover123 10 months ago