RB25 Gt3076r Dyno - 460whp@19.8 psi

This was with a 40/60 mix of ms109 and pump gas. I made 430whp on canadian piss 91 octane and 17.8 psi of boost. Car was tuned by myself with a ViPEC ecu. I wish my torque numbers were better.

Setup(well the big stuff) -
Mostly stock bottom end rb25
Gt3076r .82
256 cams with OEM spec lift
Tomei valve springs
Tial 38mm
ViPEC ecu
OS giken twin plate


NOTE:
STOCK headgasket
STOCK coils
STOCK oil pump drive
STOCK pistons

Category:

Autos & Vehicles

Tags:

• rb25
• laurel
• r33
• gtst
• gt3076
• dyno
• pull
• run

[Zacho222]

In 4th gear on the dyno about 3700-3800. If you want to see a datalog/curves of the run send me a message with your email.

[misterquealy]

Hello, just wondering if this is still running? Has there been any mechanical issues?

What kind of torque did it produce?

[misterquealy]

Hello, just wondering if this is still running? Has there been any mechanical issues?

[Flattrate]

Good power, i have a 3076R on my RB25 as well, what exhaust manifold are you using...

My dyno video is under leed16 if your you wanna check it out

[meet07]

what does swaping the rods do?? Im sure it changes the stroke right??

[sheepyg]

what rpm does it make full boost?