Bad Mustang Rod Bearing
Uploader Comments (evenexchange)
Top Comments
-
Keep on knocking but you can't come in!
All Comments (32)
-
@distantarray2 depends on if its an sho taurus lol
-
@evenexchange hell yeah mustangs rule hondas are lame
-
@evenexchange 4 times in 17 seconds? so you can do 0-60 in about 4.25 seconds in your mustang GT? 2000 mustang GT's typically run about 6 seconds 0-60 so your way off, regardless comparing an accord to a mustang is pretty terrible... that's like comparing a taurus to a 350z
-
Was this video taken like right after it happened or after driving it for a little while?
-
@snowyphil65 Phil, it started out slapping loudly as the RPMs died down to around 1,000 (pulling up to a stop sign or stop light). While I would drive at 1,500RPMs and up, I could not hear the knocking or slapping at all. One day while driving, I shifted into third gear and once the RPMs stabilized, there was a horrific loud screech, and the car stalled out.
-
I mean main bearing not piston bearing
-
@evenexchange did it start out as a slight chirp under accelleration? or did it go full on knock, my truck has had a knock for a while (piston slap i thought since its common for the 5.3's) and now has a chirp under accell that has been getting worse over the last 5-10 miles (driving it minimally), pissin me off, thinkin its either in the tranny (torque converter) or engine, rod or piston bearing
-
my turbo volvo threw a rod threw the block. it broke through cast iron engine block and looked like someone spilled 10 milk shakes all over the pavement. quell domage
That's what you get for buying a Mustang.
sweetlikeADAM 1 year ago
@sweetlikeADAM Hey Adam, please give me back the 17 seconds I wasted watching your Accord go 0-60 one time.
That way, I can go out in my GT and hit 0-60 four times with the 17 seconds I get back.
evenexchange 1 year ago 11
It's already been replaced.
evenexchange 3 years ago