HHO torch after 2 years of use

My priority is a cell that does not heat up, so efficient I think, stays clean, and easily refillable




by making separate cells is the leakage current is nearly zero .One of the biggest problems with most hho cell I meet on youtube ,leakage current = heat , I also put no more than 3 volts per cell maximum . more = heat and heat = energy loss ,if you have no heat in your cell, you will also have far less dirt and corrosion ,I use this cell for more or 2 years to soldering and 1001 and other things Where You need heat on a small place ,the bubbler is made out a stainless steel coffee pot and a rubber end piece of drain pipe
I think that removing heat and dirt is more important then playing with magnets and pulse width and so on

Category:

Science & Technology

Tags:

• hho
• cell after 2 years
• 600 watt
• torch
• h2o
• environment
• generator

[uawwildbob]

yes this is a nice set up. But at 600 watts I can see that heat will be a problem after a long run . I would say ten minutes would start to show the heat building and ya would have to turn down the volts or amps. I would say volts cause its tuff to find an amp restricting variac. But ya can use a frequency ajustable PWM. Was wondering how much gas per minute ya kick out ? i will guess about 6 ltrs per minute

[powerzap69]

Very nice set-up. I went ahead and did a video response also on your movie. Feel free to do the same one my hydrogen movies (combined veiws of 350,000) to help get the msg out. Keep up the good work.