Arduino Pong Test

This is a video taken shortly after having successfully assembled the arduino pong setup.

Forum post from code author:
http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1187659197/0

The resistor values match up, except for the 450, which I used a 470 ohm resistor. I snagged the red AV cord from an old RYW set.

At the time of writing this, I've yet to test the potentiometer controller aspect of the code. I have a 10k pot, so I have no doubt that it'd work.

I have plans to allow for a larger screen. The way that the code is written, each pixel is a byte in a screen sized 38x14, which could easily be much smaller if each pixel was a boolean value.

Expect a video of the larger screen resolution, and of course, the code to do it.

Category:

People & Blogs

Tags:

• arduino
• pong

[MotionOrbProductions]

did you use a PAL tv or an NTSC tv

[RabbidMickeyMouse]

NTSC

[MotionOrbProductions]

same exact sketch or did you modify it