VexUs plasma circuit on 4 stroke engine ("Unity")

Hi everybody, thanks for watching.!
Here is a four stroke engine, running with the plasma ignition circuit and gasoline. 50μF after the resistor, and 316 volts DC. Amperage meter is connected to the DC side after the full wave bridge.
More information at www.overunity.com
Thank you.

Category:

Science & Technology

Tags:

• water
• engine
• plasma
• circuit
• vexus
• four
• stroke
• ignition
• over
• unity
• overunity
• forum

[fingerspies]

well what a crazy mind head you have, i like your hair and think you have really nice white teeth... but you have limp wrist and a voice like miss piggy so i think you are mucho bum boy and have 17 boyfriends and a live in lover who is a goat!! i can't condone your type of lifestyle but if the goat is happy and gets plenty of leeks and carrots and i don't mean your carrot you filthy minded goat molester... i can see clearly now the rain has gone...

[Djzissis]

It's clear that your mind is far smaller than mine...it is not your care about my goat.

You can say whtever you may think behind this monitor, but i am sure that you were never able to build something like this when you were 17 years old. However this video says about an engine modification. You are OFF TOPIC man... :/

[fingerspies]

Think you are right about me not being able to build something like that at 17 but we didn't have the materials and facilities then... but can do it now, look after that goat.

[SirCuddles2006]

two reasons for increased temp. Lean mix, and you need to decrease ignition advance by about fifty percent. the heat being generated by the flame front speed is burning up the mix before the piston reaches peak torque (in degrees of rotation) and the expansion is losing power in the form of heat through the head/combustion chamber. The reason you heard a greater change in the 2-stroke was because you were greating enough heat/combustion pressure charge to partially burn the oil in the mix.

[Sloe1427]

I would try adding ormus to the water...

[2550osiosterdalen]

Ok. Good luck!

[Djzissis]

Hello my friend, thanks for waching.!!

I think I am going to try alcohol that mixes better with water.

Future test will show all.!!

[2550osiosterdalen]

The engine became hotter too, probably because of too lean fuelmix. BUT that was WITHOUT plasma spark! Good luck to you!

[2550osiosterdalen]

Try with 5% water first and move up step by step. Try with ordinary tapwater versus microwaved tapwater to see if there is any difference. I put some water in a regular lawnmover without plasma, and it was microwaved. The rpm rised clearly before it stopped an minute afterwards. I think that the water i put in slowly diluted the petrol and when it became too much, the engine stopped. I never could get the engin to start with water in the petrol.