mr2 10.09 @ 141
Uploader Comments (widebody91)
All Comments (7)
-
very good
-
Dtcobra -Not as much as you would think..there is an mr2 in the usa running 10.88 with 450whp on a gt3071r (iirc) and still retains a lot of OEM engine parts! 500bhp, good setup ,good launch could easily see 10's. good Gt35r mr2 setups are capable of 9's !
-
I've run 38 psi tapering to 31 on a Honda before, 585 whp. The weak link is the stupid ball bearing GT35, which falls apart incessantly. Garrett is good enough to trade trashed GT35 CHRA in for a rebate but all the ball bearing Garretts are junk. Journal > ball bearing.
BTW, it's not pressure it's whether the engine can flow at a given power level and if the engine has the piston-wall, etc, to hold the power. I've made big power off of stock rod cast piston engines built "loose".
-
you do not want to run 27psi of boost on gt35, unless you love rebuilding and have tons of money.I'd say about 15 runs on any type of honda/toyota/ford/chevy/etc motor with this kinda pressure and you'll be looking to rebuild over again.
-
good
That run was on about 27 psi from a GT35, which is approximately 560 rwhp. It is tuned to roughly 34 psi
widebody91 4 years ago