go kart part 5

Here is the new frame, thicker steel box section. And a new 25mm cadet axle and hydraulic brake.

Category:

People & Blogs

Tags:

• go
• kart
• part
• 4
• slalomflex28

[FizzleMC]

how do you attach the wheels to the motor or the engine?

[slalomflex28]

For many of the questions it is going to be easier fo you to look back because I will have surely answered the same questions before. The engine has a centrifugal clutch fixed to the crankshaft. The drum has a 219 pitch gear on it. It uses a live axle so when you attatch a chain around the clutch on the engine and the sprocket on the axle the engine will drive both wheels. The axle sprocket it attached via 6 mm key steel as there are keyway slots in both the axle and the sprocket carrier.

[Swartz8806]

Hey,

What hardware/components did you use to secure the steering shaft to the frame?? Looks almost like bearings.

Thanks

[slalomflex28]

Refer to comment on part 4, Thanks.

[wagon3333]

Hey its me again i was wondering what did you use to link brake pedal to master cylinder, looks like some sort of tie rod...Thx 5*

[slalomflex28]

It is. It is actually a steering rod off a mobility scooter. You have to be a bit inventive with projects like this.

[TheBenlar]

did u have a spring to return the brake pedal?

[TheBenlar]

how did u fill and bleed the brake fluid system? thnx 

[TheBenlar]

did u have a spring to return the brake pedal or not. Thnx

[julianleeho]

where did u get the brakes? r they hydraulic?

[USApunk07]

where can i get one of those bakes

[500passwords]

cool vids , just need a little narrating , i guess you get more comments your way though. maybe i should try that on my videos. keep up the good work

[leem1994]

nice!

[ejvdo]

I need a new rear end on my gocart i need his exact setup