Turbo 2007 GSX-R 600
Uploader Comments (jcopnhvr)
All Comments (62)
-
@GOBbluthagain well dynos vary so it might read 110 stock on a different dyno, just depends what type of dyno
-
this kit sucks dont get it. there is no rr reg so its so lean when your on boost and melts the piston. (happened to my 07 750 with this kit) only way this kit will work is to drop your comp to under 10 and get a rr fule reg and a scav oil pump. after that the bike will be a rocket
-
no bike will out run another bike its the rider i had an 07 gsxr 600 with bolt ons exhaust pc3 dyno tune and -1 front sprocket kn air filter i could out run 1000s and bigger bike all day long cause i knew how to launch 10.6 1/4 on stock wheelbase that run clutchs were gone little more than half way down the track you do the math prolly would have been a 10.4 run well with 1000s 1/4 mile above average rider times so its not the power of the bike its the rider skill
-
First of all does this kit work with stock internals and at what boost level was this bike dyno at.
-
sorry but your gsxr was only putting out 99 hp stock??? is that the wheel figure? my 06 gsxr600 was putting out 117 hp stock.... summit not right with ya figures chap
-
Y is stock whp so low? Since they have 125hp @ crank, i figured it'd be around 110whp...
-
You are all fuckin' stupid.
-
You are all fucking stupid. Good entertainment though. I find it hilarious when guys act like little bitches.
-
They're not the same comments over and over. I mentioned 11,000 RPM only twice. I must've gotten my specs from a bad source, or not thinking at the moment. If you weren't such a fucktard, and could comprehend how Youtube works it's comments, you'd realize that they are all typically listed twice.
In the time line of the replies, and the dates of all the overall comments.
Either way, it was over a year ago. If anyone's the mistake, you are. Mr. self righreous, because you read stuff, LOL.
-
oh ok... that's why you make the same comments over and over and over again right buddy? because you made a typing mistake... i bet you're a mistake
This comment has received too many negative votes show
actually i didint watch it,i know the outcome, a very minimal hp gain and a very big headed owner with empty pockets, just thought id share the a simple fact to discourage others from making such mistakes as boosting a 600.glad i could help !
greengoblin636 4 years ago
Well thank you for commenting on my video that was made over a year ago and I'm sure that everyone here knows that if you want to make big numbers from a turbo 600 (which is a badass ride) you need something other than a stock motor.
Anywho, I need to stick to my new years promise and not give haters the time of day...they never have anything intelligent to add to anything, and when they try, they are always wrong.
jcopnhvr 4 years ago 4
This comment has received too many negative votes show
another complete waste of time and money.
greengoblin636 4 years ago
Clever, and just think....not only did you take the time to watch it, you took even more time to make a unintelligent comment. Thanks for watchin!
jcopnhvr 4 years ago
Sorry about the cut off at the end, youtube keeps on taking the last 7 seconds off of my clip. The text reads:
Stock: 99.85hp 40.55 ft/lbs.
Turbo: 124.95ph 52.26 ft/lbs.
This is a very safe tune with pump gas on the stock motor at 4.5 PSI!
jcopnhvr 4 years ago 3