Hans' Open header run

79 camaro 305 with open dynomax headers, 1-5/8" primaries to 3" collectors
Due to many comments (Thanks!) I thought I'd just sum up:
This video is more than a couple years old now. The motor was cold and had no choke- little rough on start up!
More importantly, I've got a 350 zz4 block, zz4 cam, wiseco forged flat tops, brodix IK200 heads, th2004r and 3.73 rear end in it now... So - maybe I'll put up a sequel vid?

Category:

Autos & Vehicles

Tags:

• Open
• Headers

[1979corvette1]

sounds nice man hey got a question. Did you notice any diference in performance with the edelbrock intake manifold and carb? im thinking of doing the same setup on my monte carlo

[skaaltel]

@1979corvette1 on the poor old 305 I noticed a huge difference. The original cast iron manifold and 2 bbl carb was in a bad way. Most of the emissions systems were broken and the engine was full of sludge. In the process of swapping the manifold I fixed all that. The engine ran a lot better and the sound of the 4barrels opening up was REAL sweet.

[1979corvette1]

@skaaltel do you still have this car??

[skaaltel]

@1979corvette1 Yeah, I sure do.

[localdu]

im a car tard.. what are open headers??

[skaaltel]

@localdu Exhaust exits your engine from several ports. Headers bring all these sources together into one (or two) locations. Normally they are attached to long pipes, converters and mufflers and sent behind your car. "open" headers have no pipes attached. It's a lot like setting off a few little bombs every second and attaching little megaphones to them. I hope this explanation helps!

[blunts4dayzzz]

love tha car.. and great atitude my friend. five stars

[pentium3fan]

dude that sick! in a good way man i wish people

drive with open headers instead of fucking hybrids and those super quiet cars they suck!!

[brandon6622]

EXACTLY!

[zabner12]

ATTA WAY to treat forged pistons.

[trx254]

runs like sht

[jakobklug]

thats sweeeeet. love the car

[SkidRock088]

That look on his face.. thats exaclty how im going to act when i get done working on my iroc. :D

[rroberts383]

WABAA! haha i love her reaction, and then yours. Check out my built 383 vid with open headers

[saintcasper24]

Nice!!!!!!!!!!

[Joker28th]

rock on brother who cares about noise complants

[timberlol]

ugly ass piece of shit, it belongs in the crusher, have a nice day.

[castro4456746]

"you are going to get a noise complaint"

"EXACTLY!!!!" LOL nice video