Welding Tricks...

OSHA around?

Category:

Science & Technology

Tags:

• Mig
• Welder
• Lincoln
• Channel
• Renovation
• Ladder
• Mask

[123xyzbnm]

why are you welding outside with a mig machine, you must dislike sheilding gasses.

[CORVAIRWILD]

@123xyzbnm It was alot lighter than my ARC welder

[landonu12]

oh yur from alberta? where in? im from ponoka, just north of red deer, or lacombe too

[CORVAIRWILD]

@landonu12 alot further east!

[renegade323]

It'd be more impressive if the weld actually looked good, looks like a pass that any average welder could do with one hand.

[CORVAIRWILD]

@renegade323 It was just to hold the c channel for a minute

[Robert260288]

wind sorry

[Robert260288]

i dont like weld with mig outside because co2 going with the winter

[joelalay1]

Good job?

[martingmcnamara]

Buddy, anyone with welding experience knows that that is NOT a quality weld,ok its not going to break but its not a weld id like to have posted on youtube with the world knowing i was responsible for.Sorry.....

[TheKmannn]

i hear a GE AC4400 CW locomotive in the back ground, or maybe a GE ES44AC 

[RichardsMetalWorks]

booger welds!

[RyersonRobert]

I like your vids but for christ sake get some else on the camara your making me giddy.

[KurtisWM]

@CORVAIRWILD

some people are stupid eh, lol

[1998bhdawn]

little lincoln175 mig to easy

[rdecaserio]

Dont feel bad but thats a non consistant ugly weld!!

[landonu12]

@CORVAIRWILD oohh k hahahaha its just one of the comments said haha

[CORVAIRWILD]

@mikeandsara2007 If you'd read the comments below, you's see that you're not so brite... I was just hanging off the iron to make a temporary ledge to weld a cross C channel on. It needed to hold the C Chan up for less than a minute!

[mikeandsara2007]

i think i seen a seagul fly by and take a shit.... wait no its your weld. I hope that is not seen by any one ore atleast load bearing. i hope whoever your are working for didt see that weld

[mageac]

@moseseseseses a friend of mine made way more then that welding in alberta...

he was getting 37 an hour, plus time and a half over 40 hours...

and basically did no actual work....

[CORVAIRWILD]

@thaiwomen and hanging on not to fall. It was just to support a C Channel for a minute... Thanks for the positive comments

[CORVAIRWILD]

@moseseseseses Nah, but thanks!

[moseseseseses]

Offshore welders earn $2,775.00 per 84 hr. work week. If you would like to work offshore, send to me your email address. Thanks.

[thaiwomen]

ahh i know i have to give you credit at the angle and with one hand :)