#7 hho torch trials

This is a new configuration of the housing with the same plate arrangement.I have increased the wire size to #6 stranded copper.I used 5/16 brass bolts and brass nuts and washers at the electrical contact points inside at the stainless conductor strips and outside at the copper wire terminals.I put 1 1/4 inch diameter zinc plated steel washers between 5/16 split ring lock washers to act as cooling fins.I changed the stainless electrical conductor strips connecting the plates to the brass bolts from the 1/2 inch wide strips to a much thicker gauge and about an inch wide strip of stainless.After the run you see here the inside water temp was about 170 degrees F. I dissassembled and inspected the parts to find Heat damage to the home made hdpe washer on the negative terminal on the inside of the housing.This conductor strip is much shorter than the corresponding positive conductor and I believe the positive strip benefited by being cooled by the solution.I also noticed as the solution turned red from what I believe is iron coming from the plates production increased a lot as evident from the increase in flame size and temperature.The climbing temperature of the solution also probably increased the gas output also.

Category:

People & Blogs

Tags:

• hho
• hydrogen
• generator

[powermaks]

so this turns watter/electrolyte into co2? or just plain energy?

[mymessagetomark]

@powermaks

electrolysis seperated the water into hydrogen and oxygen gas

[MrHelpfulvideos]

I made 3 generators and they keep messing up, blew up in my car like 5 times water and shit everywhere. What do you use for the container, what material? Glass?

[mymessagetomark]

@MrHelpfulvideos

Oh id stay away from glass for safety reasons

[mreisma]

can you boil water with this torch or would it mess up the glass container?

[mymessagetomark]

@mreisma

certainly you can boil water but remember its only abot 70% efficient so it might be more efficient to just boil the water with the energy used to make the gas

[isbemorph]

i wonder would it help removing broken flush exhaust manifold stud, maybe even burn it out

[mcwario13]

what are your plates made of?????

[federicoramos]

@MrOrencillo LOL!

[mcwario13]

what do i use for an electrolyte then? besides Sodium hydroxide

[fishfrizbee]

wow with a solar panel and a Drycell you could cut a car in half

[jsmythib]

4:05 I heard Hank Hill :-) Nice project, thanks for posting.

[XLosSantosX]

@legogunguy001 thank you very much for your help

[legogunguy001]

@XLosSantosX The flame does not go into the tube because it is traveling at a high speed through the orifice in the torch, the same reason that a natural gas flame doesn't go back into the line in a stove. If you are scared I would recommend a flashback arrestor.

[XLosSantosX]

One thing I dont understand is, why does the flame not go into the tube... I mean its is HHO Oxigen and hydrogen. I wanna build one but I am scared of blowing my bubbler up... Some Ideas to make it secure?

[Ramiromasters]

What is the bubble bottle for?