01 f150 5.4L BLACK BEAUTY
Uploader Comments (vigdahl)
All Comments (37)
-
@mountianbikeer theres only 1 way to stop it from getting fucked replace the cam set up with a high end one before the shit hits the fan
-
i did this with my 4.2 v6 triton 97 f150 and the rolling cams cant handle the work that a chip will put on the motor eventually they wear out and the pistons drive the valves right into the block and the motors fucked . ya thats a true story mine it only took 20000 kilometers on the chip before i fucked my motor
-
@rekjavicxxx But what they don't tell you is that when you tighten up your torsion bars they ride like shit. every bumb in the road you will fell.
-
luv the deep sound
-
man i would be so anoying with that truck!! o_O
-
@mikqaz666, p.s. How many miles ya get out of that shitty chevy drivetrain? How many transmissions ya gone through?
-
@3506767, it wasnt that cold when i started it, had only been there half hour tops on a warm like 30 degree day, and back then the motor was fresh, now im rockin 140000 on motor and 300000 on rest of truck. So yeah @mikqaz666, SUCK IT BITCH 300000+ miles
-
@mooose09 and redneck025, light bar under tailgate doesnt come on because i cut the wire for park lights and installed a tail light cut out switch, for them recon nights. Lol
-
@ninezerofour, i only took out the rear 2 cats, the front ones pretty much burnt themselves up and came apart ibside so i hollowed them out and put em back in. It also has true duals and gibson shorty headers now. Ill post a new video asap.
-
GET IN MY CHEVY BITCH!!!!
Nope no check engine light for me, i eliminated that problem by reducing the pipe in small sections where the muffler and cats were to 2 inch to keep back pressure, the rest is 2.5 inch with 3 inch tips. I should have a new video soon i now have gibson headers on it, i think i might throw some slp loudmouth on it and get crazy, and ohhh yeah its deffinately a cop magnet...lol
vigdahl 2 years ago
Did you have to put a lift on to clear the 33's? I'm considering that tire. I've got the 2" leveling kit, but wanna make sure there's no rubs.
rekjavicxxx 3 years ago
Nope no lift, just tightened up the torsion bars and had it aligned cause it did rub the bottom of the plastic valance just a tad but not anymore.
vigdahl 3 years ago