CV Boot Replacement - STRETCH Boots

How to replace CV Boots on the vehicle without dismantling the driveshaft's! Using the amazing air operated "CVT-1000" CV Tool and STRETCH CV Boots. The CVT-100 is a trade quality diecast aluminium CV Boot installation tool that is manufactured by PTW Tools. Also manufactured by PTW Tools are the amazing STRETCH CV Boots.
www.ptwtools.com

Category:

Autos & Vehicles

Tags:

• Stretch cv boots
• ptw
• cvt-1000
• cv tool
• driveshaft
• front axel
• cv joint
• stretchy
• change
• universal
• bootslider
• boot gun
• boot slider

[nathansnation]

this is just a bad idea because without spiting the axle apart there is just no way to properly clean the old grease and road contaminates out(thats the important one) and you cannot properly repack the new grease which without splitting the axle. The only thing you need is about an extra 15minutes, a vice and a sludge hammer

[ptwtools]

@nathansnation A CV boot should be replaced when it is perished, before it splits open and allows road contaminants in. Before our CV tool was available, CV boot replacement was often not cost effective and most boots/joints were left to fail resulting in a higher cost and less environmentally friendly shaft replacements a few months later. By using our CV tool and boots, the life expectancy of a CV joint can be extended considerably. That's good for workshops, customers and our environment.

[vitiay]

do not show this tool to proctologists :)

[mandykal]

I guess it helps if you have the right tool...

[wesmath1]

thats cheating! lol

[TheRhino303]

Thanks for the upload its good. i have replaced it for my car and charged for £100, is it reasonable or i have overpaid for it.... ..

[WildeTanteAnna]

Perfect idee.

[wwwagstaffe]

Or you could just buy a cone for 5 bucks off ebay which lets the gaiter stretch straight over the driveshaft!

[swanz199]

Nice tool. Too bad autozone don't loan them out.