AceMachine Twin Turbo 383

The parts that will make up the Castrol Syntec Top Shop Challenge engine build

Category:

Autos & Vehicles

Tags:

• AceMachine
• twin
• turbo
• 383
• engine
• fuel
• injection
• race
• syntec
• chevy

[mikewashere01]

hey im trying to intall twin turbos on my 355 and im trying to figure out where you tap into the engine to get the oil for the turbos i got drain lines into the oil pan but where do u get the oil from??

[jtheaceman]

@mikewashere01 You can t off of where the oil sending unit is at the back of the block near the bellhousing & distributor. Sometimes the blocks have an oil hole at the front of the block near the intake that u can use.

[mikewashere01]

@jtheaceman do you have to use an oil pump or is it presurised because i found the spot by the distributer like you said

[jtheaceman]

@mikewashere01 It has pressure, so no additional pump is needed.

[aptara1]

Didnt these guys end up in last place?

[jtheaceman]

@aptara1 Yup we ended up dead last! Most power & dead last! It was still a fun project, the rules just favored the import engines, just the way it goes.

[aaronbed1]

hey xltroll13.dont get all pissy when u make a fuckup.learn motherfucker.

[XITroll13]

@aaronbed1 I know what I'm "on about" needle dick. I have a block with splayed main caps out in my garage. The bolts just didn't look like they are angled in the video. Fuck off back to australia.

[aaronbed1]

this is a splayed cap block you muppet.small blocks only have the center caps spalyed.dont comment when you dont know what you are on about.

[jtheaceman]

Two different types of stainless & really thick stuff!