my protege 5 running bad don't know problem #1
Loading...
Uploader Comments (deathtrigga)
All Comments (14)
-
where did you find a motor for your car...i need to find one for my car
-
do you still have this problem? because that can be your engine fuse!!!!!
-
i can hear the head gasket in the video. what did u do to blow the head gasket? run it too high an rpm?
-
You have a compression problem! Scan the check engine light.If you have a p301, its a compression. get it tested.
-
It can be a compression problem also! my cylinder one is only pushing 30psi,when it should be at 120-130 psi. I changed the coilpacks, the injector and the spark plugs. If the sparkplugs are crusted it could be the injector BUT BEFORE you spend 100.00 for a new injector, check the compression. Check the check engine light if you have a P301 code you have a misfire!!!! meaning it could be the O-rings or the pistion Sorry!!!!!
-
This seems to be the same problem that I have with my 1991 Mazda protege. Did yours burn allot of oil? Because my car sounds the exact same way when I try to start it and it takes FOREVER to start then when it does start it runs really rough for a minute or two then smooths out. After that it smokes allot and likes to stall out in the worst places. Unfortunately it's just as hard if not more hard to start when the engine is warm.
-
im gonna have to go with the ignition coil packs the protege comes with two.. instead of your standard distributer .. but first check your sparkplugs .. when you turn it over it sounds like it wants to go.. do not crank engine for more than 10 seconds or it may cause more problems.. but if you were messing around near the pulley your timing could be off .. also an easy fix just look for the timing marks and line it up
-
Check your whole ignition system. That's mind-boggling.
-
is the mass air flow in the wrong side ???
1:46
2002 Mazda Protege5 available from Sprint Auto Salesby SprintAutoSales3,359 views- 1:12
Mazdin dyno Run and top speed.by Bitonovski3,880 views
- 3:01
mazda protege 2001by GroupeVincentVideo3,949 views
- 0:54
0-80 Run in Mazda Protege5by betekvs2,883 views
- 1:42
PROTEGE 5by m2latino4,144 views
- 0:33
2002 Mazda Protegeby goodchevrolet3,344 views
- 0:52
Protege5 Attackby DannyRoth23,224 views
- 41 videosCars
- 0:10
CorkSport Power Series 99-03 Protege Exhaust at idleby Daspion24,752 views
- 4:55
MazdaSpeed Protege 350hp turbo 20 psiby killerbeeQC11,293 views
- 0:34
Mazda Protege 5by buitrami19,342 views
- 0:37
my protege 5 running bad don't know problem #2by deathtrigga906 views
- 3:56
How To Replace An Ignition Coilby canobd238,720 views
- 0:32
Mazdaspeed Protege: Dyno Pullsby justinlansdale19,891 views
- 1:32
Mazda Protege 5 soundby Agent9212,078 views
- 1:02
what the hell is this noiseby techeazy8013,333 views
- 1:05
02 Mazda Protege 5 Clicking Noise - What is it??by MarianeJorgenson21,242 views
- 3:43
Seafoam 2002 Mazda Protege5 137000 KMby pr5owner20,354 views
- 0:40
mazdaspeed protege vs 350zby sleepermsp27,900 views
- 12:51
400whp 373tq Protege5 Signature Sound Wagonby signaturesound4651411,765 views
- 2:28
mazda protege tuning speadby bboybih32,714 views
it was the head gasket guys the MAF is in the correct area..
deathtrigga 2 years ago
turned out to be blown head gasket. fixed it still something wasnt right, timing seemd off and there was heavy valve tapping, so i got new motor and trans still have the old one doesnt seem like a serious problem mayb just new lifters or something are needed
deathtrigga 3 years ago
yes
deathtrigga 3 years ago