Solar Photovotaic Grid-Tie Hardware

This is the hardware setup between two photovotaic arrays on the roof and the feed back utility meter. First stop is a PV disconnect switch, two inverters, second disconnect switch and then a wire from each inverter is back fed to a 20 amp breaker.

Category:

Howto & Style

Tags:

• Solar
• Photovoltaic
• PV

[depravedpuma]

I can see the inverters are the red boxes what are we looking at in the pen start from left to right clock wise.

Thanks

[cooasty]

@depravedpuma The feed from the inverters goes to the Square D disconnect box, then back fed to two breakers into the grid.

[MegaAlfie007]

Say Much!

Whats What?

[cooasty]

@MegaAlfie007  I'm a man of few words. The install speaks for it's basic simplicity.

[cooasty]

The solar package was purchased from Pacific Energy Company, 2121 Santa Barbara Street, San Louis Obispo, Ca. telephone 805+544-4700

[cooasty]

I did not install the system. Just wanted to show the simplicity of it......Thanks

[ralree]

That's a lot of nice hardware to just have hanging around outside...

[chen5668]

@cooasty where did you buy the system?

[treemonkey1994]

I like the set-up. No audio? Did you install?