Halogen Cycle in Globe

The lamp is equipped with an open tube that permits the halogen gas to be withdrawn and re-introduced as desired. When switched on, the filament is operating in a vacuum. After a few seconds the bulb is observed to blacken; this is caused by tungsten atoms that evaporate from the filament and condense on the bulb wall. Once completely blackened, the halogen gas is re-introduced back into the bulb. It quickly begins to react with the tungsten that has been deposited on the relatively cold bulb wall, and transports it back to the hot filament. The result is that the wall is returned to its original clarity. In this experiment the concentration of halogen gas used is higher than normal so as to achieve the rapid clean-up. In a standard lamp, the speed of the halogen regenerative cycle is much slower, but it operates continuously to prevent the bulb from blackening and thus maintaining a constant light output during lamp life.

Category:

Science & Technology

Tags:

• Halogen
• Cycle
• tungsten

[MucusFelidae]

Experiment done by an experimental master magician!