Barely Balancing Parallax Propeller Based Robot
Loading...
Loading...
11,404
Link to this comment:
Share to:
Uploader Comments (joebotics)
see all
All Comments (9)
-
very nice! -- Balancing is one of the most difficult things to do in robotics.
-
That's awesome, good job!
-
excellent!!!!
-
Brilliant!
-
Hehe it looks like a giant hammer!
-
thanks. I receive parts on Thursday. Subscribe to my channel so u will know when i upload the videos. I have already subscribed to yours.
-
what microcontroller are you using? are you using a 8-bit adc or a 10-bit adc?
Loading...
- 0:56Stepper motor with Arduino + L293Bby kosmosLabs4,966 views
- 1:27Parallax Propeller DEMO - Memsic 2125by ICPolyman6,255 views
- 0:43Balancing robot on gravelby DANVELVILL11,849 views
- 1:04Hard drive brushless motor run by a Parallax Pr...by kevlar42919,755 views
- 0:58Sportster XL883N Iron, V&H ShortShots @800 rpmby damoru11,075 views
- 2:55X-Racer game on Hydra / Parallax Propeller Chipby avalondreamsjtc7,782 views
- 0:53Two Wheel Balancing Robotby PlaniTechnic49,096 views
- 0:45Harley Iron with Edge Sikpipesby joebotics88,856 views
- 9:25Props 101by chippedprop494,688 views
- 0:13Suicide Sportster 48 Previewby GoodnightTechnology125,738 views
- 2:41Bicycle Robotby kamigh10,910 views
- 1:33Unibot - 3D stabilizationby jvpommeren269,979 views
- 0:55GUI for propellerboxby jonathancocaud5,326 views
- 6:54Skate or Die with 2 Parallax Propellers and a C...by oldbitcollector77714,793 views
- 0:27Mini Balancing Robotby AliRezaKohani5,132 views
- 4:09Integrated Spin Code Debugger for the Parallax ...by mydancebot2,099 views
- 1:35Incredible Message Machineby davefletch724,809 views
- 1:56Unicycle: Phase1: Lateral balanceby DANVELVILL4,235 views
- 1:20RF Tilt control of tank with Propeller at SIUby dawgzooka1,207 views
Thanks!!... done subscribing to yours!..
joebotics 3 years ago
i read your email. I will post a video of my robot when i compile hours of video into 10 mins. I am actually upgrading it by using the idg300 and the axon microcontroller. I have a question? are you getting better results with the 12-bit adc or is there alot of noise that alters the angle calculations?
heribertor88 3 years ago
Hi... the IDG300 is a great choice.. about the ADC, I just followed what others did in order to interface with the gyroscope + accelerometer combo, well, both analog outputs are pretty noisy, I observed similar behavior with either 10bit or 12 bit ADC, but the Kalman filter does a wonderful job in processing both the gyro and accelerometer noisy outputs and delivering a rock solid angle value.. I hope this helps.. :-)
joebotics 3 years ago