Micro mid motor 3ch aileron plane

Close ups and flights in my room and backyard. At the last of the video, elevator actuator has lost its torque because of battery run out, I guess.

Wingspan 260mm, Length 250mm, Height 130mm, AUW 9g. Material, EPP(lightest density) 3mm thickness,Receiver IRX3, Lipo FR50, Motor MK06-4.5, Gears 9T/60T Module 0.3, Prop Homemade, 0.2mm thickness Polystyrene 105mmDia, Actuators 0.05mm(AWG44) UEW, For Ailerons 10mmDia 300turns. parallel connection 2coils approx50ohm (approx100ohm each). For Elevator,10mm Dia 230turns approx70ohm. Magnets 3mm Dia x 8mm Height(Piled up).

Category:

Science & Technology

Tags:

• rc
• 3d
• plane
• epp
• foamie
• hover
• ir
• indoor
• slofly
• torque
• roll

[familyguy2939]

what kind of glue did u use

[036036]

3M Scotch plastic adhesive

Synthetic rubber clear adhesive

CA glue

[familyguy2939]

are they proportional acuators. i am building a foamie out of scrap and want somthing that doesnt just turn on and off. where did u get the motor, what brand

[036036]

Check out "DIDEL","Plantraco"

and"BSD Micro RC".

[UKrocketeer]

how did you make the transmitter?

[036036]

I assembled completed circuit board and some parts from

"Indoor Airplane World e-shop"

[elvill1]

dude you better be getting paid to do this because your good - real good!

[bballman59]

isnt that a 4ch? flies great btw

[10paperplane]

can you do a video that you sho how to make it?

[edu01jose]

sell it to me!

nice vid

[familyguy2939]

lol. i just built mine. not like this, only rudder and throttle control, flies great, used all the componets from an aerosaur