Drilling a hole to blank on a lathe.
Loading...
Loading...
1,952
Loading...
Ratings have been disabled for this video.
Uploader Comments (NOPPAWUNDER)
see all
All Comments (3)
-
Good job. Like Peruturner said - a forstner bit will do a better job because a spade bit tries to follow the grain in the wood and runs off-centre. Also, run your lathe at the slowest speed and hold the jacobs chuck with your left hand to stop it coming loose. You are doing well.
Brendan
-
try a forser bit is much better
-
you should use a forsner bit is easier
Loading...
4:54
Drilling the mounting hole in a custom turning tool handleby SegmentedTurner5,065 views- 0:37
Center Drilling on a Latheby ManufacturingET24,362 views
- 9:42
Segment #2, pen blank preparationby johnnycnc15,180 views
- 6:26
Drill Chuck for a Lathe Presented by Woodcraftby woodcraftmarketing7,604 views
- 3:57
Peck drill (very small holes on the lathe)by Dividedhead155,019 views
- 2:44
Wood turnig by drill ドリル木工ろくろ A drill lathe for woodcraftby noho9153,485 views
- 9:23
Drilling a mounting hole in a woodturning tool on the latheby SegmentedTurner2,471 views
- 1:44
Parting Tool Techniqueby PeterGalbert192,618 views
- 9:44
Building a Lathe chuck for a drill 1by etherick18,864 views
- 3:35
TurboLatheby markscs1,115 views
- 2:58
Ornamental Turning -- Profile Probingby dngarrett4,240 views
- 8:54
Treen How To Part 1 You Tubeby jrbeall3315,622 views
- 3:44
Home made lathe toolby revieck23,348 views
- 3:33
COLT MaxiCut Forstner Bit Systemby MiebachCentrale30,853 views
- 0:51
square hole drillingby jacquesmaurel365,463 views
- 6:32
Making a Wooden Knitting Needleby JenkinsWoodworking18,596 views
- 1:10
Dedicated Pen Blank Drilling Chuck at Penn State Industriesby PennStateIndustries23,778 views
- 0:28
Deep Hole Drilling on CNC Lathe using KSEM Indexable Drillby MCtooling11,634 views
- 8:12
Tool Handle, Drilling The Hole Revisitedby gmertl2,728 views
Yeah, i would use, but i dont have a forsner bit, Sorry. Thanks Brendan.
NOPPAWUNDER 2 years ago