Hi everyone!
I thought I would make this video to show how you can modify your intellicig cartridge.
The result of the mod will make the draw back alot easier than it is from standard.
I have tested a few other ecig brands including "e-lites" and "Skycig" and have to say that the intellicig is by far the best UK ecig in producing vapour/ build & performance.
The only thing the others had was one small plus point, and that was they seemed slightly easier to smoke/vape. I decided to see if I could improve this and seemed to have managed to find a possible design improvement.
Put 1 or 2 small pin holes 11.5mm from the end of the cartridge (the end that goes over the atomiser). This pin hole should be just above where the inner cartridge (that holds the e-liquid)
I have found 2 holes to be the most effective, but if you have 2 you can then alternate between 1 or 2 by placing a finger tip over one of the holes to increase or decrease the suction required.
I am considering doing more videos on:
• E-liquid reviews and suggestions
• Why electric cigarettes are the future of smoking.
Along with any other suggestions anyone can make.
I hope you all find this helpful and that it works as well for you as it has for me.
Happy vaping!
Thanks very much! I stumbled across the idea for the modification as my girlfriends only negative point (which is admittedly a small one) was that she found it hard to draw back hard enough to produce enough vapour and hit. I played around with a couple of spare cartridges and decided to put a couple to increase the air intake..... and I lucked out and it worked :o)
Yes indeed I am English for my sins but it's very nice of you to say so, I have to say I am quite fond of the American accent to
RobsGmail 10 months ago