1997 Nissan Altima Custom 2dr sedan Tuner

1997 Nissan Altima GXE: 2dr sedan with R33 full body kit, molded rear bumper and side skirts, widened fenders, modified front bumper, shaved rear handles,side moldings, body line and badges. functional custom hood scoop (cold air ram), closed on bottom exhaust port, slimline custom open grille, painted middle pillars, side view mirrors, wipers and jams. Sonar headlights, Spring taillights, Pilot fogs, ADR Interspeed 18" rims with Nexen rubber. Bomz short ram intake, SS headers, N1 cat-back, straight through cat., UR crank pulley and no a/c.

Category:

Autos & Vehicles

Tags:

• 1997 Nissan Altima GXE
• 1st gen altima
• custom body kit
• custom altima
• 97 altima
• tuner nissan
• tuner
• custom nissan
• DG
• CIK
• CIKmotorsports
• CIKmotorsports.com
• Bd
• car
• BDs
• motorsports

[AlabamaCotton]

the 3rd and 4th doors are still there....

[BDleFunk]

@AlabamaCotton

The rear doors are still there. They open from the inside. The title of the video is a play on words and just for fun. I wanted it look like a 2dr sedan on the exterior.

[arobb8]

hey where did you guys get the parts to do all that?

[BDleFunk]

@arobb8

Some parts came from Ebay. The 4pc kit came from VIS-racing. The hood scoop and front grille were made by me, out of fiberglass. The cat deleted headers and cat-back exhaust came from, Nopi. The underdrive pulley came from, Unorthodox Racing.

[ysm0fd3s]

This body kit will be stuck to the front and rear fender?

So it's need to cut front and rear fenders?

[BDleFunk]

@ysm0fd3s

The kit is a wrap around. The rear and front bumpers wrap around the fenders and the quarter panels (Normally, screws hold them on). No cutting on the car is needed, but maybe on the actual kit for fitment. On my car, only the rear bumper and side skirts are permanently stuck to the car. The front bumper can be removed in case it is damaged.

[lorddelapepsi]

dam thats clean

how much did this whole project cost?

[WeLoveOurDogs22]

Damn looks great!

[BDleFunk]

@ysm0fd3s

The turn signals are behind the bumper facing down. The square air ducts on the far corners of the front face of the bumper get illuminated. The ground below the bumper on each side also gets illuminated. The front turn signals are visible at night, but not during the day. The corner lights on the headlights have also been switched to dual filament bulbs.

[ysm0fd3s]

It's very nice.I'm also using this car.

But you change the body kit,where is your car direction light?

[BDleFunk]

@ljpynoi

The kit you looked up is the same one (VIS R-33). In the video you can see that I modified the R-33's turn signal/ air ducts to smooth the front bumper face. I also smoothed the body line that is on both sides of the front bumper. I cut the ducts out and fiberglassed them up. The I used bondo to finish it. I used bondo to smooth the body line, also. I wanted a clean look.

[ljpynoi]

howd you make the front bumper look like that? i looked up the body kit and it looks like it but yours look more customized